BIONIME Rightest GM300 Manuel d'utilisateur télécharger pdf (Page 12)

Batteries Installation

Your meter kit comes with two AAA, 1.5volt, batteries uninstalled. New set of batteries will provide power to perform about

1000 tests under normal use. The low battery symbol " " will keep appearing on your display if your batteries run

low. Please keep spares on hand and replace the batteries soon when a battery symbol appears.

The meter will automatically turn off after 3 minutes of nonuse to save battery power. Your test memories are still saved.

4. Meter will do electronic runing-test and the whole screen will keep blinking as soon

as the batteries are installed.

5. Press any button to close the running-test of the meter, and enter setting mode.

6. Please set time and date when the batteries are replaced. See Setting the Time,

Date and Unit on page 23.

PRECAUTION

- Danger of explosion might happen if battery is incorrectly replaced; replace only with the same or equivalent

type.

- Please follow the local regulation and discard used battery properly.

2. Install both batteries at once.

Be sure to put battery in

correct direction.

3. Slide the battery cover back

until it snaps into place.

att

ery

1. Turn the meter over.

Press and push battery

cover to open.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 78 79

Pas de commentaire

BIONIME Rightest GM300 Manuel d'utilisateur Page 12